We purchased this machine in 2021, in the upgraded stainless steel version, 100% stainless construction, 220 3 phase, great tool, just not the best fit for what we needed, make an offer, it's taking up valuable room and we need it gone. This machine doesn't use any abrasives, it's great for final cleaning, especially small parts like injector lines or castings...you can easily fit cylinder heads or even an engine block in it, though we only used it for smaller parts.

From the Vapor Honing Technologies Website:

Our Hydro Blast high pressure parts washer is backed by the industry’s best LIFETIME WARRANTY
100% built in USA
American tech support Monday – Friday
Right hand side load door
LED for great visibility

Adjustable spray wand for fan to fine point spray adjust ability
Digital temp readout for precise temp control
Auto shut off timer kills all heater power for safety
Two cartridge filters clean and strain the parts washing fluid for longer operating life of cleaning agents
Service connections are on the back of the machine for easy access. Our simplistic design allows for lifelong lasting performance
1/4″ NPT air connection is located on front left leg for main air connection
Window wiper for great visibility is standard on this machine
This machine is fitted with our heated hopper for hot washing solution which melts oil and grease on contact

Internal working Dimensions33″ W x 30″ D x 28″ H

Power220V 3 Phase

Abrasives AmountNO ABRASIVE

Water Amount18 Gallons

PumpLow Volume High Pressure Pump

CompressorSmall Air Compressor Needed (15 CFM)

PSI1700 PSI Max Pressure

AssemblyNo Assembly Required

(Shipping not included in price. Buyer is responsible for pickup or shipping arrangements)